INSTALLATION
OF SHELL SERIES
Browse Shell
Series >>
Installation - Use a white thin-set mortar formulated for interior
and exterior wall installations. Spread the adhesive with a notched
trowel (in many cases a 1/4"X1/4" square-notch trowel
will work well) following the manufacturer's recommendations. Spread
only as much adhesive as will be covered with the tile within 15
minutes.
Install Shell Series leaving even spacing between tiles of at least
1/16" (1.5mm). Use plastic spacers whenever possible. Install
control joints where the tile abuts restraining surfaces and around
the perimeter of the tile work. Allow the adhesive to cure according
to the manufacturer's instructions (at least 24 hours). Grout with
an unsanded grout to prevent scratching of the surface. Grout joints
should be filled to approximately 2/3 of the thickness of the tile.
This allows light to reflect on the internal surfaces of the tile.
Cleaning - For routine cleaning, any non-abrasive cleaning compound
that is recommended for either glass or tile (such as Windex, ammonia
mixed with water, vinegar mixed with water, etc.) can be used. Follow
rinsing instructions carefully.
|
